Ooma Forums

Before I purchased my Telo I called to inquire if this system would work with my allworx 6x phone system. After installaion of the ooma I connected it to my allworx server, and I can't make any outgoing calls I've deleted my sip proxy and can't get it anything to work.

niqhunter:
Have you tried Modem-Router-Ooma? Connect Ooma to one of your Router's LAN ports. Don't connect anything to Ooma's "Home" port.

Are you feeding your Telo PHONE port to the analog input on the Allworx 6x? That configuration will treat your Telo number as a regular PTSN line. You will be limited to one at a time call with this configuration because a second simultaneous call must be made using a Telo proprietary handset. I would also suggest that you go to setup.ooma.com with a computer connected to the Home Network port of the Telo and (I believe it's under the network tab) set the choice for MAC address from the default Automatic to Use Built-in.

Note that at the present time, you cannot use the SIP capabilities of your Allworx 6x to connect to the ooma servers so you will have to use the Telo ATA and the FXS port to connect your Allworx box.

I am using it connected directly to the phone connection on the allworx. I only mentioned removing the sip configuration because before I did that I would be able to receive a dial tone on my system, but not be able to make an outgoing call. If you are familiar with the allworx system what changes in the outgoing lines setting do I need to make to make outgoing calls?

Given that you are using Ooma dialtone the same way you used your landline dialtone with your system, have you enabled 10 digit dialing on my.ooma.com?

viewtopic.php?t=11128#p77393