Ooma Forums

I have an older Telo, part #110-0102-300. The Linx I just bought won't register. I press the Page key for three seconds and get a recording that says "registration not enabled. Your registration number is 4126." The Linx status indicator continues to flash amber.

I tried the reboot sequence in the Quick Start Guide *#*#302 and the Telo rebooted but would still not register.

Thanks for any help.

Is this the Telo with 11 illuminated buttons or the newer one with no illuminated buttons?

If it is the former, connect to the web page built into the Telo and select the DECT tab. It must be in HD2 Handset mode and not in Telo Handset mode. Also there must be at least one of the 4 slots unused. I suspect it is in the wrong mode because it shouldn't be announcing a 4 digit pin. The change can be done from that screen. It's been a long time but my ancient memory is telling me the star command must be done from a telephone connected to the phone jack on the Telo. My memory may be faulty.

It is the former with the illuminated buttons. How do I connect to the web page built into the Telo?

I got it figured out. I retried the process in the Troubleshooting section of the Quick Start Guide and got it to work, which changed the handsets to HD2.

Thanks, murphy, for your help; you confirmed the problem which led me to try it again.

I have a newer Ooma Telo, and just got a Linx. The Linx will not register -- says "registration not enabled." How can I get the Linx to register?

Connect to the web page built in to the Telo and look at the DECT tab.

How do I do that (connect to the web page built in to the Telo)?

Connect a computer to the Home jack on the Telo.
If the computer has wireless capability, disable it.
Connect to http://172.27.35.1

Select the DECT tab on the left.
It looks like this: