New Installation Questions (Connections and QoS)
Posted: Fri Jan 01, 2010 11:47 am
Hi everyone,
Got my telo up and running finally this morning! I have some questions about my config setup, things that arent clear to me after reading through many of the posts this morning.
1. My configuration is Cable Modem --> Router --> telo. When I tried to connect everything with the ooma between the router and the cable modem the telo would connect (and it did its firmware update) but I would lose all internet access. The router could no longer get an IP address from my provider. Now that Im running I would be interesting in knowing what the issue was?
2. Because of how I have configured the telo I assume that the QoS settings on the telo no longer apply and if I want to make full use of QoS I need to configure this on the router. Correct? I run a Linksys router with Tomato firmware, which give me a full suite of QoS options - just want to be sure thats where I should spend my time.
Thanks to all for your help - this appears to be a well supported active forum.
Mark
Got my telo up and running finally this morning! I have some questions about my config setup, things that arent clear to me after reading through many of the posts this morning.
1. My configuration is Cable Modem --> Router --> telo. When I tried to connect everything with the ooma between the router and the cable modem the telo would connect (and it did its firmware update) but I would lose all internet access. The router could no longer get an IP address from my provider. Now that Im running I would be interesting in knowing what the issue was?
2. Because of how I have configured the telo I assume that the QoS settings on the telo no longer apply and if I want to make full use of QoS I need to configure this on the router. Correct? I run a Linksys router with Tomato firmware, which give me a full suite of QoS options - just want to be sure thats where I should spend my time.
Thanks to all for your help - this appears to be a well supported active forum.
Mark