Ooma Forums

My configuration is mainly due to the fact that my modem/router/switch are all located in the basement since my house is wired. Does anyone have any comments about my results?

Greetings,

I followed the notes from indie_dev and with clarifications/corrections from hedstrom - to the letters - to setup my Ooma Telo. It worked right off the bat.

The Ooma service has been online for five days and the experience has been positive, so far. I'm now waiting for my number to be ported from ATT and cannot wait to cancel my land line for good.

I just want to say hello to everyone, particularly thank you to indie_dev and hedstrom for providing a good "cheat sheet".

Kevin

cukev wrote:I just want to say hello to everyone, particularly thank you to indie_dev and hedstrom for providing a good "cheat sheet".
Kevin

Welcome aboard. I've been running 2 Hubs behind my DIR-655 with this exact setup for almost 9 months and both have continued to work perfectly even under heavy network traffic conditions.

Bill D

can you explain

Go to QOS Engine Rules and set one for the Ooma device as follows: Name: Ooma VOIP, Priority:50, Protocol: Any, Local IP Range: in both boxes, enter the IP address reserved and assigned to the router

why do you use the router ip address shouldnt you use the ip address of the ooma?

indie_dev thank you very much for this very helpful information, it worked like a charm and I now enjoy very good quality using my Telo, I have had the Dir-655 Router for over a year now and did not know how to get the Ooma Telo setup behind it. I followed your steps 1 by 1 and got super great results. again, thanks a lot.