Can I use a wireless ethernet bridge with ooma hub?

Need extra help installing your Ooma Hub or Telo system? Let us know.
Post Reply
Posts: 13
Joined: Sat Feb 06, 2010 7:40 pm

Can I use a wireless ethernet bridge with ooma hub?

Post by JamRowZ » Wed Mar 03, 2010 9:31 pm

I'd like to use a wireless ethernet bridge with my ooma hub so that my router can be in my bedroom where our DSL comes in and my hub can be in our living room where it's easy to get to and won't wake someone sleeping up when someone leaves a message.

We originally planned to run wires from the bedroom to living room, but my spouse suggested "making ooma wireless" so we don't have to plug anything into it.

Our current setup is DSL modem/wireless router (all in one) > ooma Both computers use the wireless network to connect to the internet and we haven't had problems with talking while someone else is online.

Basically we want to replace the ethernet cable that connects ooma to the DSL modem so we don't have to run wires to put the hub where we want it.

Before we buy a wireless ethernet bridge, I want to verify that we're getting the right device and that by sending the signals wirelessly won't affect our QoS.

Posts: 317
Joined: Fri Mar 06, 2009 4:46 pm
Location: Plano, Texas

Re: Can I use a wireless ethernet bridge with ooma hub?

Post by mthomtech » Thu Mar 04, 2010 1:11 am

My guess is the standard answer would be "No" ... not because it won't work, but because the wireless connection will add a lot more variability and Ooma just wasn't designed for it.

With that said ...

I personally have tried this out, and used a wireless bridge on my Telo system. I had the same concerns as you did about whether it would work well, so I bought a refurbished bridge on ebay at around $50 to try it out. It worked great for me, and I tested it for a week continuously. The reason I wanted it was to be able to use Ooma while traveling internationally for a couple of months. I knew that several places would only have wifi, so I wanted to be able to use Ooma whether I had wires or wireless internet available.

The bridge worked on my travels, but using a "public or shared" wifi signal adds even MORE variability, so the results weren't always stable, but were still good.

Your situation is a little different since you want wireless to be your permanent solution. My personal preference would be to stick with a wired connection, if you can. I ran A LOT of cat5 throughout my house for everything networked, because wired connections are simply more stable. But, if you find either cheap bridge or one that you can try and return, give it a try.

That was the long answer ... the short answer ... it works, but it's not preferred (and not recommended) :)
Ooma Customer since March 2009
Ooma Hardware: Hub/Scout(2) and Telo
Premier Member

Posts: 81
Joined: Tue May 19, 2009 2:37 pm
Location: Duluth, GA

Re: Can I use a wireless ethernet bridge with ooma hub?

Post by MakoCSH » Thu Mar 04, 2010 5:54 am

It's worth a try if the AP will be close to the bridge. QoS will be tough since it's based on your internet speeds which will not be as stable using wireless. I would turn QoS off completely in this situation (unless you do a lot of heavy downloading all day.)

That being said you could get a WRT54GL ($60 new), flash it with Tomato, and set it up as an Ethernet bridge.

I did this for my PS3 (which is on the opposite side/opposite floor of the AP in a 2500sq^2 house), and my throughput went from 5 - 8Mbps (using PS3 wireless) to 20Mbps+, and pings went from ~70ms to ~20ms. What I'm saying is you should be ok (although YMMV.)

Post Reply