Motion Sensor Naming

[LarryS11]

I have named all [4] of my MS. The base station [Ooma telo] will properly announce [2] of the sensors by the name I have assigned - but refers to the other [2] sensors generically. I,e; "Motion Sensor detects motion" - instead of "Kitchen - detects motion". Any clues for getting the system to properly register, recognize & announce the actual names of all MS's?

[thomasm]

Sometime back I complained about this very issue and Ooma posted a list of all the words that are in the telo not only for naming sensors but also voice announcements.

If you do some searching in these forums I'll bet the list is still there.