New Area Code Added - 10 digit dialing
Posted: Sat Jan 08, 2011 7:31 am
Starting on 2/26 we have a new overlay area code being added. At that point we will be required to dial 10 digits in our home area code, like many other parts of the country. Right now we can still dial 7 digits, but this changed on 2/26. Currently we can also dial 10 digits to get used to the new system.
If I try to call a local number using 10 digits I receive a busy signal. This happens even when I check the 10 digit dialing box. I'm not sure the cause of this, or if we will have to even use 10 digits with the Ooma system. Can anyone shed some light on this for me?
I have a Telo connected to a Homeplug device, the other end of the Homeplug is connected to my router. We ported our number over so I have the Ooma phone jack plugged into the wall to send phone service through the whole house. This system seems to work well, although we have had a few dropped calls. It has been set up this way for about a month.
Joe
If I try to call a local number using 10 digits I receive a busy signal. This happens even when I check the 10 digit dialing box. I'm not sure the cause of this, or if we will have to even use 10 digits with the Ooma system. Can anyone shed some light on this for me?
I have a Telo connected to a Homeplug device, the other end of the Homeplug is connected to my router. We ported our number over so I have the Ooma phone jack plugged into the wall to send phone service through the whole house. This system seems to work well, although we have had a few dropped calls. It has been set up this way for about a month.
Joe