Glows blue then 30 seconds later blinking red

Having trouble placing or receiving calls or using your voicemail system on Ooma Telo VoIP Phones? Post your questions here.
JFB2019
Posts:6
Joined:Mon Jul 15, 2019 7:01 pm
Re: Glows blue then 30 seconds later blinking red

Post by JFB2019 » Wed Jul 17, 2019 7:31 am

Well, a factory reset to the AC68 seems to have done the trick. No idea why because I didn't change any settings other than updating the firmware as requested by the router since I bought it.

I have had trouble with Ooma for about 6 months. To the point of replacing the unit. Then them sending me another unit to replace the new unit... still it ended up being connected for about 1.5 minutes and then flash red.

No idea why even to this point, but since a factory reset of the router, all indicators are blue.

No issue with any other device wired or wireless on my network during this same period. My wireless speed is back up to around 189mbps.

Anyway thanks for that assist here and hopefully, this post will help someone else!

Regards
Jim

murphy
Posts:7554
Joined:Tue Jan 27, 2009 12:49 pm
Location:Pennsylvania

Re: Glows blue then 30 seconds later blinking red

Post by murphy » Wed Jul 17, 2019 9:21 am

Ooma maxes out at 100 Mbps.
That is why mine is behind my gigabit router and not in front of it where it would limit my 250 Mbps service.

SIP-ALG should always be disabled.
Customer since January 2009
Telo with 2 Handsets, a Linx, and a Safety Phone
Telo2 with 2 Handsets and a Linx

Post Reply