Page 1 of 1
setup in advanced network configuration
Posted: Fri May 22, 2009 9:21 am
by scottlindner
I have my Ooma hub configured in an Advanced Network configuration. It's just another device on my network. I cannot access setup.ooma.com without digging out a laptop to connect to the HOME network port. I would like to be able to hit the IP address of the hub from within my LAN to access the setup page.
Cheers,
Scott
Re: setup in advanced network configuration
Posted: Fri May 22, 2009 9:35 am
by WayneDsr
In ooma setup, put 172.27.35.1 in ooma's DMZ.
This will allow you to access ooma setup from your pc with out connecting to the HOME port.
WARNING: Only use this if you are using ooma behind a firewall, as I believe you are.
Wayne
Re: setup in advanced network configuration
Posted: Fri May 22, 2009 9:43 am
by scottlindner
Dang. I didn't expect there to be a solution. I guess I should have probed deeper before posting the request. Lesson for next time.
Cheers,
Scott
Re: setup in advanced network configuration
Posted: Fri May 22, 2009 10:49 am
by WayneDsr
I should have told you that you need to type in the ip address given to ooma from your router, not setup.ooma.com.
Wayne