Page 1 of 1
All circuits are busy
Posted: Mon Sep 17, 2012 8:33 pm
by drchipster
A few weeks ago I started to get the message "All circuits are busy" when making calls. The calls usually went through after several attempts (sometimes up to 3 or 4 times). It went away last week and everything was good for one week then it came back again today. I tried both prefixes *98 and *96 but to no avail. It's very frustrated when I'm late for a conference call and have to try dialing several times. I have firmware 60080 if it makes any difference.
Re: All circuits are busy
Posted: Mon Sep 17, 2012 10:34 pm
by thunderbird
drchipster wrote:A few weeks ago I started to get the message "All circuits are busy" when making calls. The calls usually went through after several attempts (sometimes up to 3 or 4 times). It went away last week and everything was good for one week then it came back again today. I tried both prefixes *98 and *96 but to no avail. It's very frustrated when I'm late for a conference call and have to try dialing several times. I have firmware 60080 if it makes any difference.
If not already enabled, enable ten digit dialling at
https://my.ooma.com/system .
When you dial the number, try dialing the complete number. Example: 1-xxx-xxx-xxxx
Same for Ooma Telo prefixes *98 and *96. Example *98-1-xxx-xxx-xxxx
Try dialing with a different phone.
Press the phone keypad buttons slightly slower and slightly longer before releasing the button.
If that doesn't help contact Ooma Customer Support:
Customer Support
Email:
support@oomacare.com
Phone: 1-888-711-OOMA (6662)
Monday-Friday 7am-7pm PST
Saturday-Sunday 8am-5pm PST