harryy300 wrote:60 % of the calls when I pick up the phone the phone does the same thing as if removing power and plugging it back in, (red lights blinking for about 30 to 45 seconds) i then must call back the caller, i have had this problem for 8 months and did everything. so only if you have had this problem and solved the problem why not tell me what you did. Thanks, Harry (again)
Also a factory reset may help.
Factory Reset Ooma Telo - Old Alternate Manual Procedure
1. Remove power from the Ooma Telo.
2. Repower the Ooma Telo.
3. Line 1 & Line 2 lights come on.
4. Line 1 & Line 2 lights go out and the Trash and Envelope lights come on for a very short period of time.
5. The Trash & Envelope lights go out and the bottom row (runway lights) starts scanning to the right. (sequence above may be slightly different with later firmware visions)
6. When the scanning stops, the Ooma symbol will began flashing Red.
7. Press the Trash button, then the bottom row Stop button (small square button).
8. Hold both the Trash and Stop buttons pressed until told to release.
9. The Ooma symbol will alternately blink Red and Blue.
10. The Ooma symbol will turn solid Red.
11. Release the Stop and Trash buttons.
12. Wait for a short period of time. The Ooma Telo will cycle back into a reboot.
13. After a successful Factory Reset, all Ooma Setup settings will be Factory.
If you are using an Ooma Wi-Fi dongle, you have to access Ooma Setup and rescan for the Wi-Fi network before a Wi-Fi connection can be made. The same is true for DSL, if you have to enter Connection type PPoE and a Name and Password for the Internet provider connection. You may want to reset MAC address to Use Built In, reset your Quality of Service Upstream/Downstream Internet Speed settings, and Bluetooth settings if you are using Ooma’s USB Bluetooth dongle. Ooma Telo handsets will have to be re-registered.
Hub and/or Scout factory reset sequence:
1) Remove the power for the Ooma device.
2) Hold down the Ooma tab [blue light] and connect the power. Hold for 30 seconds until all the lights start flashing.
Once the lights stop flashing, release the Ooma tab and the device will reset to factory settings.
Some people say they have to do the reset several times in a row before they have success.