Page 3 of 3
Re: Handsets seem to lose sync with Telo while idle
Posted: Tue Sep 20, 2011 1:46 pm
by Bill_B
KEM wrote:The new firmware update lists a fix for this issue. I'm anxiously awaiting it to be installed on my Telo system.
- KEM
Yeah, that's what I hope, too. However, when I came home tonight and did my daily ritual to wake up the #3 handset, it was already showing that the
handset update had failed. I tried to have it retry the update, and the first time it took a few minutes to download, then came back with the same failure message. Upon further attempts, it doesn't show any download progress, it just waits a few seconds and shows the failure message.
Re: Handsets seem to lose sync with Telo while idle
Posted: Tue Sep 20, 2011 2:28 pm
by thunderbird
Bill_B wrote:KEM wrote:The new firmware update lists a fix for this issue. I'm anxiously awaiting it to be installed on my Telo system.
- KEM
Yeah, that's what I hope, too. However, when I came home tonight and did my daily ritual to wake up the #3 handset, it was already showing that the
handset update had failed. I tried to have it retry the update, and the first time it took a few minutes to download, then came back with the same failure message. Upon further attempts, it doesn't show any download progress, it just waits a few seconds and shows the failure message.
I wonder if the factory Telo Hanset reset would help?
To reset the ooma hand set.
1. Turn off the HS by press & hold the End/Red button
2. Press & hold the two keys: Left soft key and '0' (zero) key
3. Turn on the HS by press the End/Red key
4. Let go the keys in step 2.
The HS will goes into auto registration mode, so you may have to re-registor the handset to the Ooma Telo.
If this don't work, call customer service and report problem.
Re: Handsets seem to lose sync with Telo while idle
Posted: Thu Sep 22, 2011 5:01 am
by Bill_B
Tried the factory handset reset, and re-registered them all with similar results. I have an email into support to see if they can shed some light. In the meantime, for others...
After resetting and re-registering the handsets, old #3 is now new #1, and it behaves properly. However, when I try to perform a handset SW update, it continuously indicates an update is already in progress. I've tried to do a factory reset to it several times and it still thinks its performing an update.
Old #1 is now new #2 - it actually behaves fine and believes it has the latest SQ update available.
Old #1 is now new #3 - #3 STILL loses sync, though, it seems that it is easier to "wake up" than before. Usually I had to push buttons on #3 several times to wake it up, now I only have to push once or twice. New #3 continuously fails the SW update, however. Perhaps that is part of its problem?