After you leave a voicemail the OOMA Telo power cycles?
-I am using the most updated Firmware 35452.
-I am not using a OOMA Telo Handset.
-Connection is Cable Modem > Router > OOMA Telo, I have also tried Cable Modem > OOMA.
-I have a 12Mbps/2Mbps upstream/downstream.
-A landline from AT&T is still connected to the OOMA Telo because I am in the process of waiting for a port of my number.
I first suspected my Panasonic phone but I tried it with a basic corded phone and still ran into this issue. Is this normal? Or is this a solution to an issue addressed in a previous version? Any help will be appreciated, Thanks.
I checked it again and it might not actually by a power cycle or it might be but I watched the OOMA Telo again and I noticed that when the voicemail message ends with the "Thank you for using the OOMA voicemail system" a few seconds after all the lights go out except the "1 and 2." Then all the lights go out for a second and the lights will illuminate following a power on sequence.
Telo with 2 Handsets, a Linx, and a Safety Phone
Telo2 with 2 Handsets and a Linx